DJI O4 Pro Air unit mount for Flylens 85
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DJI O4 Pro Air unit mount for Flylens 85. You can print the mount in TPU and use the M2 inserts from the old mount
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 162
- Wydruki
- 1
- Wyświetlenia
- 623
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
DJI O4 Pro Air unit mount for Flylens 85. Wanted a TPU mount as the original one was cracked in less then a week (bad at flying it seems :) )
You need to use the original M2 inserts from the original mount or other M2 inserts if you have. I pressed them with a plier instead of adding them the traditional way and they seem to stay in place just fine.
Printing Settings:
Filament: 95A TPU
Nozzle: 0.4
Layer height: 0.2
Perimeters: 3
Supports: Yes
Infill: 40%
For best results, print it at low speeds. This print also allows for a better reach for the SD card as this clears the entire SD card slot.
Printed weight without the M2 inserts is 3.4 grams. Don't know the weight of the original one as mine shattered in a crash.
The bottom part is 2mm thick as I wanted a bit more protection. If weight is an issue for you I can add a separate model with the bottom part being only 1mm.