Creality CR6 Optical Sensor Activation Target - Longer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you move the optical sensor lower than the stock position, this longer target ensures you can still tare the probe.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you lower the CR6 printer bed (e.g. by converting to a rail-mounted bed), it can result in the x-axis fouling the top of the optical sensor before the nozzle reaches the bed. While Klipper ignores that sensor, the Marlin-based CR6 firmwares do not.
I created a small bracket to lower the sensor to a height that clears the x-axis, but then the stock target (24mm long) was too short to tare the probe at the usual height. This target is 8mm longer than stock, allowing you to install the optical sensor up to 8mm lower than stock, which should be more than enough.