Creality CR6 Optical Sensor - Adjustable Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After some CR6 mods, the x-axis can foul the top of the optical sensor. This mount lets you lower the sensor.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Marlin-based firmware for the Creality CR6 printer uses an optical sensor to trigger taring of the nozzle probe.
To trigger the probe taring, a small target mounted to the x-axis is presented to block the sensor.
Some printer modifications (e.g. converting the bed to being rail-mounted and installing a flexible plate) can lower the bed so far that the x-axis actually fouls the top of the optical sensor - where it is mounted to the face of the gantry - preventing the probe from reaching the bed.
If that happens to you, this little bracket can be mounted to the side of the gantry, with a single M5 bolt & T-Nut. The optical sensor can then be screwed to the bracket with just one of the stock M3 mounting screws.
CAUTION: Since the M3 screw head protrudes a little above the sensor, this bracket requires you to mount the sensor a little lower than the stock installation, which could cause the taring to occur a little lower and later than on stock machines. If that causes a problem for you, try replacing the target with this longer one, like I did.