1 / 3
Solder iron stand and clip-on base for 8586 Station — zdjęcie 1
1 / 3

Solder iron stand and clip-on base for 8586 Station

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The top stand part grips the ceramic part (that comes with the lose stand in an 8586 solder station kit) just right so…

Ocena
0 / 5
Polubienia
8
Pobrania
28
Wydruki
0
Wyświetlenia
368
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

The top stand part grips the ceramic part (that comes with the lose stand in an 8586 solder station kit) just right so it does not slip out during use.

The base snaps on to the outer body of the solder station just right and the iron is now firmly on the table in a convenient spot -- great for those crowded workspaces.

Print Settings

Printer:

RepRap iTopie 400+

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

30

Filament: PolyMaker PLA Grey and Pink

Notes:

I'd used Cura to generate GCode. Note that at 20% infill, the clip on action was not very good, definitely recommend 30%. In Cura, that made the infill pattern switch to linear which worked very nicely.

The part was printed longest edge up with the widest portion in the Y-direction. It was plenty stable for printing at 60mm/s that way.

Also, used the support blocking feature on base portion that mates with the top part to block support generation in the already created holes of the base.

Print time was about 10h for base and 5h for top part.

Category: Electronics

Tagi