1 / 3
Storage container for CR20XX button cells
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
We had several packages with button cells flying around in a drawer. The way those cells are packaged also makes it really hard to get them out without using scissors or a knife. I wanted a more convenient and less messy storage solution, so…
… I designed and printed this pretty, yet admittedly a bit overengineered, storage solution for CR20XX button cells.
How to install - no tools or glue required!
- Print out the following parts:
- 1x Container
- 1x Lid (either labeled or unlabeled)
- 3x Slider
- The lid should be printed on the flat side
- Insert the sliders into the container with the flat side facing the bottom
- Install the lid by pushing the 4 little pins into the respective holes of the container. It should be a snug fit.
Recommended material and print settings
- As this is just a simple storage solution, you can use pretty much anything that is non-conductive. The material I used was standard PLA (orange for the slider, and white for the container).
- No supports, no brim
- 15% Infill
I would love some feedback if you printed this model - so please upload a picture of your makes!
Happy printing!