Qidi Plus 4 Beacon & Cooling fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement fan housing and duct with Beacon3D support
- Ocena
- 4,667 / 5
- Polubienia
- 115
- Pobrania
- 655
- Wydruki
- 3
- Wyświetlenia
- 4957
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
***NOTE **** This Beacon mod is FULLY FINALIZED for Klipper by STEW675 and fan system can be fully integrated with or without beacon.
****MY Config: https://github.com/FxWoody/Qidi-Plus-4-Mods/tree/main/Beacon
Support for Beacon probe with fan housing, air duct, toolhead cover, wire clip, for the installation of the probe on the right end side of the toolhead.
*** Print everything in ABS /ASA /PA6-GF (better for heat resistance) ***
4 Walls
3 top & bottom
25% infill Gyroid
The ORIGINAL 75x30x15 fan fits in the new housing, no need to buy new one. Take in consideration that the OEM fan will be spot glued at certain place in the OEM housing. Remove with caution.
The air duct is suppose to fit with a small CLEARENCE between the scraper and duct. If the duct touches the scraper, make sure the duct is well fitted on the fan housing and also verify that your scraper is not BEND.
Be aware that the ORIGINAL cover will need to be sanded to FIT new FAN DUCT system and probe support.
An extra support as been added on the toolhead cover to use a fiber optic filament to transfer LED flash into the cover for better visual (optional)
***I added STEP file of MOD cover original look ;)***
*** ADDED NEW STRONGER VERSION FOR BEACON SUPPORT WITH FAN SHROUD HIGLY RECOMMEND USING PA6-GF FOR HEAT RESISTENCE ***
**** Beacon installation guide : https://github.com/qidi-community/Plus4-Wiki/tree/main/content/bed-scanning-probes/Beacon3D/RevH-Normal ****