1 / 1
Reinforced IKEA Faktum leg clip
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mix has tighter tolerances and is stronger where it mounts to the kick board.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 290
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed to replace the IKEA Faktum kick board leg mounts as a couple had broken. This mix is based upon a great design by @TimAngus (https://www.printables.com/make/2364636) but as I found when printing with PETG the clip was looser than the original IKEA clip. This version holds the kick board rail mount and the legs with a sliding fit. I suggest only printing it with PETG as PLA might not flex enough.