Wingnut and Spherical Washer for Jawz
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is just an additional part for use with Jawz
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I don't have a bunch of wingnuts, and I figured this would actually be a good place for a large plastic wingnut. It might be a little more in the way, but it's easier to use with cold, wet hands, and it's less likely to scratch anything or snag on nitrile gloves.
The spherical washer curvature radius is a compromise to keep the assembly short and stout. It's a bit difficult to compensate for angles this severe with a simple spherical washer, but it's better than a flat washer.
I sized this for 10-24 UNC parts, since that's what I had. I hot-set the hex nut into the pocket. The hex pocket is probably big for M5 hardware, but you can just edit that in the SCAD file.