1 / 3
M5Stack Cardputer stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Recommended to print at 5% infill with additional wall support. No supports needed and no screws or other fixings. Clean up the posts and check they are not too tight before placing the Cardputer on too firmly, it should lift off with relative ease.
This stand should work with the Cardputer v1.1, but will not work for the Cardputer-Adv as the latter has a different base profile and doesn't have the same mounting holes. See my other model for a version for the Cardputer-Adv