Hexagon Sponge Holder (with or without Drainage)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple holder for your kitchen sponge with drainage to your sink
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 211
- Wydruki
- 1
- Wyświetlenia
- 578
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
If you don't have a dedicated spot for your wet kitchen sponge after cleaning the dishes this print is for you!
This model consists of a lower “base” part and an inlay with hexagon-shaped holes. The base is available in two versions: One with an opening in the front to drain any water right into your sink and a closed one which needs to be emptied manually. The drainage-version also has a recess to better fit on your sink if it is slightly higher than your counter top. For this part of the model supports are required, the version without the draining ramp prints fine without.
I also made a bottle drying rack in a similar design, check out the model as well if you liked this one. Happy printing :)