1 / 1
Peggit - Bar Clamp Holder for Bessey 24 in clamps — zdjęcie 1

Peggit - Bar Clamp Holder for Bessey 24 in clamps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the peggit bar clamp holder to fit the Bessey 24 inch f-clamps

Ocena
0 / 5
Polubienia
7
Pobrania
39
Wydruki
0
Wyświetlenia
476
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

Description

This is an adaptation of the original peggit bar clamp holder by @RobertCowanDIY to fit the Bessey 24 inch f-clamps which have a wider bar.


Printing Instructions

Same as the original model - both the top part and the support part can be printed flat on the bed without supports. Recommend using a 0.2 layer height to ensure a good fit between the holders and the peggit clips.

For the top part recommend using ASA as the fit is pretty snug once the retaining nubs are installed and PLA might give up over time. 

The support/bottom part can be printed in PLA.

The retaining nub is the same as the original, just included it here for convenience. It should be printed in TPU (the softer, the better). 

In addition,  you will need two Peggit Clips.

 

Installation

For installation instructions and materials please check the original model. I've used M3 10mm screws for the retaining nubs and ¼-20 set screws to prevent the holders from leaning once the clamps are added.

If you are not familiar with the peggit system I highly recommend checking the original model which includes useful tips and tricks and more detailed printing instructions.

Tagi