1 / 5
8xPlier-Holder (screw into board) low filament 28g — zdjęcie 1
1 / 5

8xPlier-Holder (screw into board) low filament 28g

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

8xPlier-Holder (screw into board) low filament 28g

Ocena
0 / 5
Polubienia
2
Pobrania
24
Wydruki
0
Wyświetlenia
107
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Significantly reduced filament needed to print, modified to be screwed into a board. Used negative modifiers for holes so you can match needed size also modifier is used for back plate so either you go low filament mode like I did, or you can print full back wall to use double sided tape to stick to some other surface (you will need to delete that modifier to print full back).

Very low amount of filament is needed for my version, only 27grams !

Material used: Jayo PETG Black 

Tagi