DF83 ~W~I~D~E~ coffee chute

This chute is ultrawide. It is a lot larger, than the grounds exit hole — in fact, it is almost large enough to close the hole in the metal body of the grinder by itself.

And it is also printable without supports!

To print a declumper, import its svg into your slicer, set 0.1mm layer height and 0.2 model height, and go ahead. You can experiment with different declumpers in Inkscape — just keep the stencil outlines about the same.

I've drilled two 0.5 holes on the left side vertically of the chute about 1 cm apart from each other to insert the ionizer contacts. Do that about 1 cm from the base. Yes, I need to integrate that into model.