Elegoo Neptune 3 Pro X/Y GT2 Toothed Tensioner Pulley Mount Upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A redesign of the original N3P tensioner to allow the installation of a GT2 20t pulley without any modifications.
- Ocena
- 0 / 5
- Polubienia
- 29
- Pobrania
- 211
- Wydruki
- 0
- Wyświetlenia
- 1002
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a direct replacement for the original Elegoo Neptune 3 Pro X/Y axis tensioner pulley mounts to upgrade to toothed idler wheels.
It follows the original design so it can be installed behind the stock covers without interference.
Design was initially created to fix an issue on my printer where the belt would wonder side to side on the servo pulley. I've replaced the GT2 20T pulley with a better quality one which got rid of the pulley eccentricity, but the belt was still moving a bit even with the upgraded tensioner.
What completed the fix was replacing the belts with GT2 Genuine Gates, and checking that the belts run parallel!
Your printer must have good dimensional accuracy to make sure everything fits as expected, a set of digital calipers for measurement is recommended (small tweaks can be made with X/Y Expansions Compensation (i.e. -/+0.05) in some scenarios).
Necessary parts:
- GT2 20T idler for 6mm wide belt, 5mm bore.
- M2x18mm bolt and nut ( I had to take about 2mm off a 20mm long one).
- 2 M2 washers 6-6.5mm OD, or 1 M2 washer and 1 M3 washer stacked.
- M3x20mm or longer bolt for tensioner.
- The old tensioner wheels are reused.
- Idler mount print (check dimensions of sleeve bore to clear sleeve; and width between the 2 chamfered features, should be ~10mm wide).
- Printed sleeve (should be ~4.9mm OD for a snug-ish fit in the 5mm bores of the idler and mount).
Recommended upgrades:
- Medium Loctite to ensure idler bolt will not come loose
- GT2 20T extruder pulleys of good quality (tight tolerances on extruder D-shaft).
- Replace belts with GT2 Genuine Gates.
- Polycarbonate V-Slot wheels for the bed carriage if the old ones are worn and there is movement.
Assembly
Check everything fits together nicely before assembly (sleeve slides inside mount and idler bore without much slack; idler fits snug between mount protrusions).
- Thread the M3x20mm bolt through the hole in the middle of the mount base.
- Slide the idler wheel rougly into place and insert the sleeve until it is flush.
- Install the washers on the M2x18mm bolt and slide throught the sleeve until flush.
- Thread the M2 nut on the back (this can be finicky) (optional: add threadlocker).
- Tighten the bolt until tight, but don't overdo it.
- Check the idler wheel spins without resistance and sits centered.
- Reinstall tensioner on printer.