Omron HEM-FL31-B Cuff Hose Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement cuff hose adapter for when the one that comes with the blood pressure monitor ends up breaking.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Public Domain
In testing, this model has worked with the Omron BP7450 blood pressure monitor. It should work any unit that takes a HEM-FL31-B pressure cuff, which is also the BP5250, BP5255, and the BP7350.
Layer height: 0.08 mm
Filament: PETG
Recommended Slicer Settings: Precise Wall Enabled (OrcaSlicer), 0.95 Flow Ratio if using PETG
Must be printed with supports, I used classic supports in OrcaSlicer
The values from the blood pressure monitor appear to be within variance, I tested with a different Omron unit and found the results to be similar, around 5 mmHg difference between units.
If the cuff hose adapter that came with the unit broke off inside the hose, I recommend using wire cutters by cutting up the debris and forcefully pulling it out of the hose.
This replacement part is not 1:1 to the original part, there were a few changes I made to the part that I felt was more optimal than the original design.
If your unit gives an “E1” error with this replacement part, it is very likely that the print has warped and is leaking air. Make sure that your print has not warped (lower temperature and/or more fan speed).