1 / 8
Stacking tray for HIMI paints and small parts — zdjęcie 1
1 / 8

Stacking tray for HIMI paints and small parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stackable tray to prevent himi gouache paints from spilling into each other

Ocena
0 / 5
Polubienia
0
Pobrania
21
Wydruki
0
Wyświetlenia
181
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

This is a stackable set of trays with lids sized to hold Himi brand gouache paints, but could also work for loose paint or just small parts. The intent is to allow for both airtight storage and easy transportation of these paint tubs without possibility of spillover.

All prints seen are PLA. I recommend a nice bottom pattern at least (octagram spiral works well). No supports or brim needed. You'll want to ensure you have very good adhesion to prevent warping. For the thinner parts, you may wish to let them cool before pulling off for the same reason.

Note that you'll need a good stash of 3x6mm magnets for this (3x5 will probably do). And a roughly 4.25mm piece of tubing for the airtight seal. Plus superglue, or your glue of choice.

You'll also need to be meticulous about magnet orientation. I recommend going through a stack of them with a felt tip pen to mark one side, then always thinking of the “marked side” as facing downwards when stacked. So the bottom of the HimiTray model will show your magnet markings, as will the Lid. But the top of the tray will not show the markings.

Part descriptions and recommendations:

HimiTray

The paint holder. Holds Himi tubs with or without the foil removed. Print one for every 8 tubs you want to store. Glue rubber tubing into the outer rim for a somewhat airtight seal.

Parts:

  • 12 - 3x6mm magnets (option for more lifting strength)
  • 1 - length of ~4.25mm tubing

HimiTrayLid

Print one per tray. This is what prevents the paints from spilling. Note that the inside of each well may get paint on it, which is what the following part is to help with during use.

Parts:

  • 6 - 3x6mm magnets (option for more lifting strength)

HimiTrayLidTopper

Optional. The idea with this is that you may be on location to paint, and when you remove the lid you'd like to avoid getting dirt on it or paint that might be on the lid onto anything else. The magnet orientation on this can be a little confusing, as its open part faces up when stacked (so the marked side should be down).

If you print a stack of more than one of the toppers, put all the toppers on top of the entire stack. The 4 magnet array is not enough to lift a stack of trays!

Parts:

  • 4 - 3x6mm magnets

BrushTray

Optional. Deep enough to hold brushes and other tools (limited by the length of the tray). Goes on the bottom of a stack.

Parts:

  • 6 - 3x6mm magnets

 

 

Tagi