OrangeStorm Giga LCD Cable Management
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple parts to protect the long LCD Cable while the printer is in normal operation.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple cable management parts for the OrangStorm Giga LCD Cable. The corner clip is used to secure the LCD wire along the corner frame to keep it form hanging free. I used 3 clips, but you can use more if you want it more secure up the length of the printer.
The display cable shield is 2 parts. one that mounts under the metal bracket for the connector at the bottom, you will need longer M3x10mm to replace the three M3x5mm screws that were installed. the bottom plate should mount with the open space facing the upper right. Then the cover just snaps over with you feeding the wire out the opening.
Don't really need specific settings for the prints, the clips do require Arachne so that they can easily bend around the extrusion and snap in place.