RAMPS offset and swivel 80mm or 2x40mm Fan Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a RAMPS mount für P3Steel to offset to make room for the display and SD card expansion. Included is am mount…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a RAMPS mount für P3Steel to offset to make room for the display and SD card expansion. Included is am mount for a 80mm cooling fan which can be swivel (?) upwards for easy access to the RAMPS board.
the offset board is based an the original design from Toolson (http://www.thingiverse.com/thing:1052156)
If requested i would make a version with 2x 40mm fans.
- put part2 down flat when printing
- need to make better fotos (or not usw black )
- yes the fan in mounted in the wron direct on the fotos
- yes i need to improve the "kabelsalat" printer is not finished yet
Print Settings
Printer Brand:
RepRap
Printer:
i3x
No
Supports:
No
0.2 mm
Infill:
15%-30%
Notes:
should print nicely without any supports
Custom Section
BOM
Offset mount (Part1)
8x M3 Nut (Offset mount)
8x M3 Screw 6-10mm (may vary) for mount the board to the Frame and for mount the Arduino
Fan mount (Part2)
2x M3 Nut (for mounting the fan)
2x M3 Screw 30 mm (for mounting the fan)
2x M3 Nut (optional, not needed)
2x M3 Screw 8mm - 12mm
Category: 3D Printer Parts