4th Gen Toyota Tacoma Passenger TPU Trash Bin for Molle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A softer, TPU, trash bin to attach to the passenger side molle in the 4th Gen Toyota Tacoma
- Ocena
- 3 / 5
- Polubienia
- 12
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 830
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dad had another accessory that he wanted for his 4th Gen Toyota Tacoma: a trash bin. Originally, he wanted the trash bin to hang off the center console hook on the passenger side. I told him might be better to hang it off the center console molle grid on the passenger side as it would be more secure. His parameter for the trash bin was he wanted it softer and not hard in case the passenger were to lean against it.
This is what I came up with. I accounted for the angled ledge on the center console to allow it to sit flush to the side of the center console. When it rests on the angled ledge you can see in the cover photo that it has a slight angle to the trash bin which should make it easier to put trash in from the drivers side. I printed it in Sainsmart TPU at 25% infill. I wanted it flexible but have some body to it. I can always try less infill if you want it softer.
If I were to make another version of this I would cut the top at an angle to make it flush with the top of the console molle. Maybe I'll upload a revised file if someone is interested in that. Dad was happy with how it turned out as it is. So I uploaded it as it is.
The prusa slicer file includes paint on supports for where the slots for the one wrap velcro that is used to attach the trash bin to the console.
Just use at least 6" of Velcro to attach it to the molle grid. I only cut 4-½" for the one in the photo. 6" would be better to make it easier to attach. If you have some sewing capabilities you can also fold it over and make a pull tab.
Added 2/28/25 - merged one piece file without distortion
Hardware and Materials:
(6") 1-½" One-Wrap Velcro