TEVO Tornado Filament Holder 3 / 20x20 or 20x40 Extrusion Filament Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is my third filament spool holder I made for my TEVO Tornado! Works with 20x20mm extrusion.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Here is my third filament spool holder I made for my TEVO Tornado! This spool holder fits securely into the 20x20 aluminum extrusion on top of the 3D printer frame and can be attached without taking apart the frame. It also includes a filament guide arm that keeps the filament from touching the greasy z-rod as it is pulled into the extruder. The design also uses minimal-ish filament utilizing a truss design.
I was hoping that it wouldn't require a long time to print, but nope, it takes a good 13-19 hours to print depending on your print settings. But hey, call it a easy and useful way to test your printer's long printing ability!
Also a little side note, it looks pretty cool too.
While I haven't tested it on other printers, this design can likely be used on all other printers with 20x20 aluminum extrusion like the TEVO Tornado, or printers that have other types of extrusion like 20x40. To test if the filament holder is able to be mounted on your printer, I also uploaded a little test piece that is quick and easy to print and will tell you whether the filament holder is able to be mounted on your printer. I also uploaded a version of the filament holder without the filament guide arm if you don't need it.
To mount the filament holder, angle it backwards so that the larger hook can fit into the top part of the extrusion. Then smoothly position the filament holder vertically while slightly pulling up until there is a noticeable click. This is the secondary hook snapping into place that prevents the holder from falling backwards if it is accidentally nudged that way. You shouldn't need to apply much force if you are slightly lifting up the filament holder as you are rotating it into place.
Make sure to read the printing instructions below.
Print Settings
Supports:
Yes
Notes:
There are two main positions which you can print the filament holder. Either you can position it so that it's laying flat on its back with the tube-shaped part sticking up, or you can have it printed on its side as shown in the pictures. I printed it this way because in the other position, I think it would mess up the precision of the part that fits into the 20x20 extrusion. Both ways require supports. If you print it the way I did, It is also important to lower the support degree threshold to 10 degrees or so in order to minimize the supports generated to mainly being only underneath the top part of the trusses. Also, it is a good idea to add a brim because it is a lengthy print and would be a shame to have it fail after it's pretty far down the road.
Happy printing!
Category: 3D Printer Accessories