PolyDryer Adapter, Gasket, and Stacking Feet for the Cereal Box Filament Dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a kit to support active filament drying for the cereal box filament dryer using the Polymaker PolyDryer base.
- Ocena
- 5 / 5
- Polubienia
- 93
- Pobrania
- 159
- Wydruki
- 1
- Wyświetlenia
- 3232
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- BSD License
The gasket is designed for a 63.75 mm diameter hole, whose center is to be located using the provided template. When using the template, please make sure it sits flat and the arm is not bent, so the hole is properly located. I used a 2" hole saw to remove most of the material for the hole. I then used an utility knife to cut the final hole. I cut tabs all around the 2" hole using pliers, and I bent the tabs a bit to make it easier to cut with the utility knife. The plastic lid can be a bit brittle, so it is important to go very slow and gently with the hole saw. and also with the pliers. I used a deburring tool to make a nice edge. Silicone can be used to glue it to the lid if desired.
If the filament is to be actively heated using the PolyDryer adapter, all the parts exposed to the heat should be printed with sufficiently heat-resistant plastic (PLA should be avoided). PETG seems to be doing fine with the second heat level of the PolyDryer adapter. I am not sure if it would be a good idea to heat up the cereal box with the highest heat setting of the PolyDryer regardless.
The feet were designed so they don't require support when printing. There are provided inserts meant to be printed with TPU. The stands can be glued to the feet using superglue.