1 / 13
Handheld Wifi Yagi Antenna Enclosure and Grip Mount — zdjęcie 1
1 / 13

Handheld Wifi Yagi Antenna Enclosure and Grip Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Handheld Wifi Yagi Antenna Enclosure and Grip Mount is a clamshell design enclosure for current available yagi antenna

Ocena
0 / 5
Polubienia
3
Pobrania
38
Wydruki
0
Wyświetlenia
397
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

Handheld Wifi Yagi Antenna Enclosure and Grip Mount is a clamshell design enclosure for current available yagi antenna. It provides a comfortable grip for handheld field use for direction finding using a portable spectrum analyzer (TinySA Ultra).

The grip model shown is not included as it is readily published for download and not modified here (also any compatible grip will work rather than printing one). The grip mount may be slightly thinner than other models or spec, so thicken as desired for your existing grip to be snug.  Since antenna has no weight, grip does not need to be super secure here, but wobble is not desirable.

The enclosure is designed for a flat circuit yagi antenna with end-launch SMA connector available by searching Amazon for “Antosiya” shop or “12dBi 2.4GHz 5.8GHz Dual Band WiFi Directional PCB Yagi Antenna Wireless Network Card Adapter FPV Drone Remote Control Enhanced Signal and Distance (SMA Male)”.

The clamshell is closed by snapping together.  The mount part is attached using a pivot pin and two 3mm x 12mm pan head screws and nuts. The grip is attached using a 5mm x 12mm pan head screw into a 5mm x 6mm brass 3d print threaded insert.

Material shown is PolyMaker PLA Pro using 6mm nozzle. No features are critical to layer height, but snap together case may need fine sanding/touch cleanup depending on print quality.

Cable shown is a 0.086" coax RGS-316 equivalent with SMA female connector. Antenna shown is the SMA Male model.  The interfaces can be reversed and should print and fit fine, but has not been verified.  Larger coax may be desirable for field use.  1" diameter Ranger Band (EPM rubber band) is shown at rear of the grip as a strain relief and keeper for the cable.

Cable Clip model added.  Clip shown only in pic 8 with coiled cable in clip.

Tagi