Bottle Cap Pressure Regulator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the design for a pressure regulator that sits on top of a normal plastic bottle. Because some parts are quite…
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 1547
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial
This is the design for a pressure regulator that sits on top of a normal plastic bottle. Because some parts are quite small and others require smooth sliding or sealing surfaces, this design is only suited for resin printers.
On the output side, a 6mm OD plastic hose is used.
To fill the bottle, eriher a compressorcan be attached to the 1/4 inch thread, or a bike valve can be screwed in.
When using 1/4 inch adapter with rubber seal, a check valve can be added with a spring and a BB.
Output pressure can be set by the nozzle/seat area combination, spring constant and pre-tension of the spring.
The dummy plug is not needed. It can however be used to replace the bottle for testing, or when a compressor is used.
Print Settings
Printer:
Elegoo Mars
Rafts:
Doesn't Matter
Yes
Post-Printing
Additional parts that are needed:
- Rubber membrane (cut from an old bike tube),
cut and puncture holes for screwsSmall spring (from a pen) Large spring (more difficult to find, e.g. oil filter bypass valve) M3 bolts Bottle cap Optionally BB and second small spring for check valve or a bike valve instead 1.5mm thick steel rod O-ring 17mm ID
All Parts
Assembly
- Insert the steel rod carefully into the needle. It will break easily. The rod should protrude around 3-4mm. The needle will have to be sanded to slide smoothly inside the lower housing part. Push the valve seat into the main housing part. I added teflon tape for a better seal. Cut a hole into the bottle cap and stick the bottom part through. Add an o-ring. Add a small spring around the needle and drop it on the valve seat in the main housing. screw both parts together. Cut out the membrane and add screw holes. Bolt the upper housing to the main housing, clamping the membrane between both parts. Put a larger spring around the plunger, put the plunger on the membrane and scre the top cap on.
Section view of the whole regulator
Discharge of a 1L bottle filled with 4bar down to ambient pressure. Timescale is 10s/div, discharge begins at around 10s. The pressure is held approximately constant at around 2 bar for 30s.
Category: Engineering