Air Sucker and Sealer for Ikea Freezer Bag (keep filament dry)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use the build in straw to remove air in bag and seal - keep your filament dry
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution

Did you know regular filament spools fit in the large Ikea freezer bags (called ISTAD)?
Even better, they fit in both the 4.5L and 6L bags! 30 bags for a couple of bucks.
But getting the air out is annoying.
How? Seal from one end with the straw in (facing the other end). When almost done, suck that air! Lift the straw and finish sealing.
Tip…
- Drop a little dry bag in the bag
- Write on the bag what the filament is! You will forget. (Or on a sticker so you can reuse)
If anyone could test with a Ziplock… I don't have them around me!
-------------------------------
Printing tips:
- print the straw up
- no support needed
- a brim might be good - it's quite tall
- straw is 180mm high (you need to be able to print that high)
- pla, 2 walls, 15% infill.
