PyroPatch - Improved Fatshark Goggle Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The stock mount designed by PyroDrone is pretty great, but I wanted to update it a little to suite my tastes.
This mount is strong, light and utilizes the stock fan cover and screws - just don't tighten too far since there's fewer threads holding it down. Longer screws is fine too, but so far the stock ones are working.
Designed for use with PETG, but will likely work with PLA as well. Fan mount is to be printed on its back. Antenna sleeve as it imports (facing up). Infill likely won't matter much, but 20-30% is fine. No supports required for either part. I printed with a 0.6 nozzle, but a 0.4 will work just fine.
I'm using an M2x25mm bolt and nut. No glue required, but some epoxy can be put over the wires where they press into place to keep them safe/secure.
I've included the designs in STEP and f3d format if you'd like to give it a tweak.
Print Settings
Rafts:
No
Supports:
No
0.2
Infill:
20
Category: Electronics