1 / 2
Pivot Pin Sleeve for Bi-Fold Doors
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement sleeve to hold the spring, pin, and roller in place for a bi-fold door roller assembly.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
I had some bi-fold closet doors break on me one night and it was too late to go to the hardware store. I designed this, printed in PLA, and installed it and it held up for about 2 years until I overextended the folding doors and it finally snapped. I have re-printed in PLA+ so I'm not expecting it to fail any sooner than the previous one.
Requires support in the center due to the vent hole.