Carry handle for 2.5 ton Pittsburgh aluminum race jack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Carry handle for the Harbor Freight 2.5 ton aluminum "race" jack to make it a little easier to move around.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 61
- Wydruki
- 2
- Wyświetlenia
- 399
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Add-on handle for the Harbor Freight Pittsburgh aluminum “racing” floor jack.
Based on a similar design I saw on a compact jack, thought it could be scaled up.
Is it strong enough? I don't use the jack often, but I have used this handle to carry it several times and it's been fine. Initially lifted it carefully and thought it might break, but it didn't. Since then I've carried the jack by this handle alone with good results, although the center of gravity isn't under the handle so it is a bit awkward.
Printing - I printed in PETG with five shells and a 33% infill. This proved to be sufficient, and 100% infill won't really help. The main handle and the reinforcing rings all print flat on the print bed as oriented.
Installation is easy - since I printed in PETG that has a bit of flex to begin with, I put one loop over the main hinge nut, then bent the other side until it dropped over the opposite nut. Once that was installed, I pressed the reinforcing rings over the nut loops to give more strength as it is otherwise across layer lines. I also added some glue to hold them in place. Just make sure to match the fillet cutouts in the reinforcing rings with the fillets in the handle, or they won't press into place all the way.