1 / 2
dwarf-cover-connector for Prusa XL Dwarf Cover by @Spengilang_312039 bent open by 20 degrees
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The connector has a wider gap to get the cables in without breaking it.
- Ocena
- 4,4 / 5
- Polubienia
- 25
- Pobrania
- 203
- Wydruki
- 4
- Wyświetlenia
- 1126
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 4) (Komentarze: 11)Remiksy (2)Kolekcje (36)Powiązane
no supports needed
To fit the cables in, push back the wrap as long as the connector-cover. Start on the “plug end” by sorting the wires side by side und push them into the gab carefully. The wrap of the cable can be pushed into the connector afterwards by sliding down the cabels. Close the connector-cover by screwing in the M3.