1 / 1
Simple magnetic tag for Prusa XL toolhead to indicate flex filament — zdjęcie 1

Simple magnetic tag for Prusa XL toolhead to indicate flex filament

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple little magnetic tag that reminds me that the filament tension is low to work better with flex filament.

Ocena
0 / 5
Polubienia
2
Pobrania
11
Wydruki
0
Wyświetlenia
182
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Ridiculously simple little tag that sticks to a Prusa XL toolhead to remind me that I've turned down the filament tension on that toolhead to work with soft flex filament. Doesn't interfere with printing in any way.

Printing exceptionally soft NinjaFlex on the Prusa XL, the default filament tension causes it to bunch up and get tangled inside the extruder. Turning the tension down quite a bit addresses it, but then it might slip if I switch that extruder to a rigid filament, so this little tag reminds me that I need to adjust the tension back up.

Prints face down with two colors for contrast (I used neon yellow and neon orange) - the text is only 0.05mm deep which isn't enough to put it on a new layer but is enough to use color painting in PrusaSlicer.

After printing, press in a pair of 5x2mm magnets.