HP Server PSU (HSTNS-PL14) case w/ Anderson Plug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for a modified HP Server HSTNS-PL14 PSU to house an SB50 Anderson Plug
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 725
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This case adds a cover to a commonly modified HP server power supply: HSTNS-PL14 , it may fit other models, but this is the only one I have to test with. If you want to know more about modifying these supplies to enable power on and adjust output voltage, then I would suggest reading the following guide:
https://www.dd1us.de/Downloads/HP%20Server%20Power%20Supply%20HP-HSTNS-PL14%20modified%20for%20Ham%20Radio%20use%20rev%201.0.pdf
The case has the following features:
- Hex air vents on top to allow airflow through the PSU while operating
- Countersunk screw holes to fix the front case to the PSU (rear spacer slides on first as a friction fit)
- Screws used were countersunk M3 x 4
- Friction fit Anderson plug with additional support screw in the base for strain relief
- M4 x 20 countersunk screw used, was tight enough to self tap into the Anderson plug for me, but may not work for all varieties
I've attached photos of how I constructed my assembled PSU, printed in eSUN PLA+ on a Sovol SV06 @ 40% infill