Elder Scrolls Betrayal of the Second Era Accessories
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Board game tweaks and organizers for Chip Theory Games' Elder Scrolls: Betrayal of the Second Era
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 663
- Wydruki
- 3
- Wyświetlenia
- 2976
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Public Domain
Accessories for Betrayal of the Second Era boardgame from Chip Theory Games.
Mini Chip Organizer
This is a drop in organizer to sort the mini chips into their three categories: Overland, Stats, and Skills.
There is space for 16 additional skill chips for expansions. If you have Valenwood expansion already, there there are 10 additional spaces.
Printing
I designed this for 0.4 nozzle and 0.2 layer height. No supports needed. A 0.6 nozzle will probably also work just fine, but I haven't tried it.
Square Token Organizers
The stock compartment size is very generous for the 16 square tokens of each color that come with the base game, and there is no specific place for the Valenwood tokens. So, I made some trays, much like the mini chip organizer, to drop into those compartments to further subdivide the volume.
They come in two flavors:
- A 50:50 split - each half has just enough room to hold 16 square tokens. If it feels too fiddly to pull out tokens, I recommend just grabbing the tray by the divider and lift it out.
- A ⅓:⅔ split - each side easily holds the Valenwood and a set of base tokens, respectively.
Printing
I designed this for 0.4 nozzle and 0.2 layer height. No supports needed. A 0.6 nozzle will probably also work just fine, but I haven't tried it.
Overland Chip Holders
These come in two flavors: and upright standee type and a lay flat type. Both have spaces on the bottom for a 10x2mm magnet (my 10x2 magnets are actual size 10.0 x 1.76mm). Put a magnetic or metal sheet behind the overland map and the mini chip tokens will stay put! Pictures of my solution for this are TBD.
Printing
The overland chip holders are designed for 0.25 nozzles at 0.12 layer height. I think a larger nozzle and layer height would require a different part design.
Large Cards Insert
An utterly gratuitous insert just for those who might be bothered by the way the large cards (Classes, Races, Side Quests, and Skills) slosh about inside the box.
Note: there is a slight amount of lid lift at one end of the box, less than 1 mm. It's unavoidable because the original cardboard box has literally zero extra height with Valenwood included.
Printing
Designed for 0.4 nozzle and 0.2 layers, but anything should be fine since there are no tight interworking tolerances here.
A More Comprehensive Insert
Check out user hextra ’s awesome work!