Reconfigurable Moto G Power Case

This is a variation of the case by kensikora (https://www.thingiverse.com/thing:4425758) and mc88 (https://www.thingiverse.com/thing:4589273/). I call it a variation rather than remix, because I cannot install 123 Design on Linux, and have therefore re-designed the case from scratch in OpenSCAD using measurements from these two models. Unfortunately I cannot figure out how to get Thingiverse to link back to those two designs, because every time I search for those thing numbers it comes up with no search results.

I liked the knurling that mc88 added, but (a) did not care for the bumpers as they made it difficult to put in and out of my pocket, and (b) wanted to keep the finger print sensor accessible. The scad file has four options, offering 16 total variants:

1. makeKnurl
2. makeFingerprintCutout
3. makeCornerBumpers

makeButtons Eventually I want to add a fifth option to make the camera hole compatible with a Moment mountable lens.

I am working on cleaning up the OpenSCAD file to share. I've included a few of the available configurations for now, and will upload the scad file when it is cleaned up.

How I Designed This

I wanted to remix mc88's case, but wasn't able to do what I wanted in Blender - intersections always seemed to end up with non-manifold meshes that wouldn't print. I decided to learn OpenSCAD and re-design the case from scratch instead. This is my first design in any kind of CAD, so feedback and constructive criticism are welcome!

Category: Mobile Phone