1 / 2
SICCO Filament Heater/Dryer Mount for SUMO XL Enclosure — zdjęcie 1
1 / 2

SICCO Filament Heater/Dryer Mount for SUMO XL Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The SICCO Console Mount is for Prusa XL's that already have a 3D Sourcerer SUMO XL Enclosure

Ocena
0 / 5
Polubienia
6
Pobrania
16
Wydruki
0
Wyświetlenia
595
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

The SICCO Console Mount is for those who have already added a SUMO XL Enclosure to their Prusa XL and then added the SICCO DIY 5 filament spool heater/dryer assembly under the existing XL configuration.  Normally, the SICCO unit is fastened under an XL without an enclosure.  Unfortunately, the SICCO design places the console directly next to the stock location of the XL console on the lower 30x30 aluminum extrusion frame rail.  That particular location is already occupied by the front portion of the SUMO XL Enclosure.  The other limitation is the length of the wiring for the SICCO (formally the SUNLU) repackaged console.  The result is that you have to fabricate a new bracket that will screw fasten under the lower left front corner of the SUMO frame cover panel.  This piece satisfies the requirement and keeps a nice consistent appearance with its next door buddy, the Prusa XL Console.  The bracket requires 3 self tapping screws that fit the three holes in the mounting tab of the bracket.  Very simple, straight forward job that take a few minutes to complete once you've done the print.  I initially chose TPU (Flex) filament for ease of sliding the console into the bracket, but found the weight of the console caused undue drooping.  The solution was to use PETG, but PLA will do just as well.  I used my XL 5 Head to print this with the 0.25mmm SPEED @XLIS HF0.4 Print Settings, modified for Organic supports for the 3 mounting holes; PETG filament; Original Prusa XL-5T Input Shaper HF0.4 nozzle Printer; Supports on build plate only; Infill 20%; Brim No.

You will notice that the SICCO console is shifted to the right of center.  Totally my doing, as I didn't allow enough slack in the wiring harness, and once you have the SICCO mounted under the XL with all the insulation and wiring installed, it is very time consuming to disassemble all the pieces necessary to extend the wiring the additional inch.  So please, when doing your SICCO project assembly, allow yourself just that little additional exposed wiring for just this purpose.  Enjoy!

Tagi