1 / 1
Big Phat Buddy Case (inofficial Prusa mk 3.3 upgrade) — zdjęcie 1

Big Phat Buddy Case (inofficial Prusa mk 3.3 upgrade)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This case is to use a Prusa Mini Buddyboard with Snake Firmware on a Prusa mk3.

Ocena
0 / 5
Polubienia
4
Pobrania
12
Wydruki
0
Wyświetlenia
139
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Firmware for the board https://github.com/Snake-Edition/P32-FW/releases

(Snake_i3_mk33…)

You also need an extra Mosfet for the bed (as the mk3 bed is bigger than the bed of the mini, so it needs more power). I used one made for the ANet A8.

m3 6mm screws for fixing the board and mosfet inside. m4 screws and heated inserts for the speakon NL8 connector.

You loose power loss recovery, crash detection, mmu3 or NFC support. No connector for accelorometer or GPIO. However, print quality and speed are the same as mk3.5. Ideal if you already have an improved printhead (like zOrbiter 2.0 with Revo hotend or a Bondtech BMG).

On my mk3.3 I have a zOrbiter 2.0+Revo. So I told Prusa Slicer the printer is a mk3.9. Changed the custom g-codes to the gcodes used by the mini. Also changed the picture setting to the format the mini uses. Added “M906 Z300 E600” in start gcode (snake firmware uses z600, so 600mA for two z-motors in parallel on one port. I connected both z-motors in serial, so just 300mA. E600 is for the LDO motor of the Orbiter 2.0).

Everything works fine. I barely can see any difference in quality and speed between mk3.3+zOrbiter and mk4.

Please use parts for fixing printhead and x-motor cable from the original model.