GT2 Belt Tension Meter with wider spring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified to fit a 10mm wide spring instead of the original 6mm one. Also reinforced the pins with 3 20mm long m3 screws.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 937
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This variation uses the same components as the original model, with the exception of the spring and three 20mm long M3 screws. I replaced the spring with one that is 10mm in diameter and 50mm in length, which required modifying the model for it to fit. While the slide is now thinner in the middle, it does not seem like a problem, at least in the limited time I have used it for.
Additionally, I replaced the 3D printed pins with sleeved M3 screws for more strenght. From experience, 3D printed pins do not last very long, so I changed them.