Prusa Enclosure Corner Camera Arm with Standard 1/4"-20 UNC Threaded Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A camera arm with a standard 1/4"-20 UNC threaded connector for mounting a camera in the corner of the Prusa enclosure.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A camera arm with a standard 1/4"-20 threaded connector for mounting a camera in the corner of the Prusa enclosure.
I strongly recommend printing the version of this model that takes a Standard 1/4"-20 Male to 1/4"-20 Male Threaded Tripod Screw Adapter like these:
It is also a good idea to thread each screw into the various holes before trying to attach the arm to the enclosure and camera to make things easier, as the holes will likely need a little force to get them going initially.
IMPORTANT NOTE: If you decide to print the arm with the screw post included in the print, I highly recommend considering using 100% infill for the post and then still being gentle when attaching a camera. I am not convinced that this can be made strong enough, and there is some chance that the plastic will break off inside whatever it is you are attaching it to.
MAKERS: Please post a picture with comments here of any prints/makes you do from this model so that I can see how people are using it and whether you are finding success with it. Thanks!
I initially created this model for the Reolink E1 Outdoor CX, but it couldn't focus close enough, so I switched to a Reolink E1 Zoom, which requires a different connector. You can find that model here:
