Ryobi 1600W Plunge Router Dust Collector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapts a Ryobi Plunge Router to 35mm OD Pipe
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 313
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
The Ryobi plunge router came with a clear dust collector piece that attaches a vacuum hose vertically to it. It is prone to cracking and I didn't like the angle of the vacuum hose coming out. It also wouldn't work with my new camlock universal vacuum system that I printed from another design. There was someone who already made a similar version to this on youtube, however his STL file was not available on printables or for purchase, nor could I find their online store to purchase a printed model. I also wanted a bit more clearance and his model is printed in resin which I didnt want to do. So I redesigned it from scratch.
To install the model, you undo the two phillips head screws from the bottom and take the old dust chute and guard off.
Printing instructions
I did PETG 0.2mm strength on my Bambu Lab with the tube facing the top and supports on
You will need
2x M4 x 35mm Bolts (Phillips pan heads tested unsure if Internal hex will work.
2x M4 locknuts
The nuts are a tight push fit into the pockets, then simply install the duct in the existing hole. Have the exit tube on the opposite side of the lock for the spindle because other wise it will foul, and it also means the vacuum hose is at the back while you press the trigger in your right hand.
The plunge depth is only affected by a few mm so I dont see it as an issue. But if it is causing fitment issues I will revise it in REV 2. I am also planning to release a camlock version as a remix for the universal vacuum system so you dont need an adapter.
The ID for the tube is 35mm so should fit your smaller shop vac hoses. My old ryobi shopvac hose fits in there.