Spinning Turok 2 Razorwind

This is a remix of a Spinning Turok 2 Razorwind. I modified it so it can be printed in separate pieces that does require any multi-color support on your printer.  I also split the main hub into two pieces so you don't need a raft or a lot of supports to print it.  Instead each half can lay flat on the print bed. 

You'll need to print 12 blades, 11 Plain_Bosses, and 8 Arm Accent Insert Halves.  Everything should be printable without supports with the exception of the Center Accents and the Pawl_Boss.  For the Pawl_Boss I used normal snug supports.  It will take a little work but you should be able to pull the supports out of the center with some pliers.  I didn't use supports for the blades, though I did use a brim.

Assembly is done with glue.  I would suggest dry fitting all parts before glueing.  

1. Glue the Ring Accents into one half of the Hubs.
2. Glue the small Arm Accent Halves into the slits on each hub.  It's a tight fit so some trimming may need to be done depending on your elephant foot compensation.
3. Glue the two Hubs together using the ring Accents as guides for the alignment.
4. Glue the Bosses together (including the Pawl_Boss) into two semi circles (6 each).
5. Fit the the two semi-circles of Bosses around the hub being mindful that they are oriented so the Pawl_Boss allows for the ratchet to work to make the blades spin. Then glue the two semi-circles together.
6. Glue the Blades onto the outside of the Bosses so they slightly overlap each other and cover the entire outer wall of the Bosses.