Speedybee BEE35 DJI O4 VTX Mounting Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This plate will fix your DJI O4 Air Pro VTX unit to the underside of the Bee35 frame. It replaces the factory plate/CNC.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 192
- Wydruki
- 0
- Wyświetlenia
- 1022
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Speedybee Bee35 frame comes with two options for the underside, where you mount the VTX - a single carbon fiber plate (basic version), or an aluminium CNC (Pro version). Neither fits the DJI O4 Air Pro properly unfortunately, because it is bigger than the O3.
I've remixed a good mounting plate I found (originally designed for a generic analogue VTX) and made a mounting bay large enough to fit the DJI O4 Air Pro VTX unit.
I printed it in TPU. Print it with the main plate on the printer's plate, and use supports for the central VTX bay.
The USB port is accessible.
The SD card slot is accessible.
The Bind button can be pressed if you pull down the (soft TPU) cover to expose it
You can see the LED.
The antennas easily reach through the factory frame's antenna mount. The VTX sits slightly behind and 45 degrees offset from the FC, which should help cooling, and there was plenty of room above and around the VTX when assembled.
It doesn't run too hot - I test flew it today for around half an hour and it didn't overheat (though it was 3 degrees C ambient!).
When SpeedyBee eventually release a custom CNC for the O4, that will be much better and I'll get that, but the O4 has only been out a few weeks and SB haven't caught up yet, so this will do for now!