1 / 2
Routed Wood Slot Car Track Copper Tape Application Tool
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
makes applying the copper tape to a slot car track SUPER easy.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 124
- Wydruki
- 1
- Wyświetlenia
- 567
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (24)Powiązane
Based on the original taping tool by OldSlotRacer (Luf Linkert) and sold exclusively by me, now you can print your own for personal use.
- The spool holds one roll of 3M Venture copper foil tape (7/32", 1.0mil).
- Use an M4x25mm pan head screw and M4 wing nut to hold the spool on.
- The baseplate provides a solid base to slide along the routed surface while two nylon guide pins ride in the slot.
- Use any 1/8" diameter pins you can find, but nylon is hard wearing and won't damage the slot. A printed pin could also be made quite easily. Note that the guide pins may need to be trimmed for fit, depending on the width of your slot. Test the tool in the slot before starting to lay the tape.
- Use M2x10mm self tapping socket head cap screws (or similar) to attach the lower and upper pieces, either permanently, or while your chosen glue dries.
- There is a "backing guide" to aid in directing the copper tape backing away from the table.
- Add a 1" piece of 1" wide Velcro tape (the loops, not the hooks) behind the two guide pins. This helps to press down the tape as you move the taping tool along the track surface.
Taping Tool Tips
- The tape MUST go in the direction of the arrows on the spool in order to work properly.
- This tool has been designed and tested to work with Venture copper tape (7/32” wide and 1 mil thick).
- Before you start to lay tape, push the tool around the entire track (without tape) to make sure it will follow the slot smoothly. A razor knife can be used to trim the nylon guide pegs if they are too snug in the slot.
- Stick down the first inch or so of tape by hand to start.
- When laying tape, you DO NOT need to press down hard, but you WILL need to burnish the tape afterward using a rigid item with a rounded edge such as a disposable lighter or spoon.
- The pad just behind the taping slot will help push the tape down without damaging it. Use light downward pressure as the tape is laid down, then burnish once complete (see above tip).
- Do NOT stretch the tape with the tool or by hand, otherwise it will curl and/or break. Tight corners may have to be laid by hand to prevent tearing or stretching.