1 / 3
Focuser Brace for 150mm Newtonian — zdjęcie 1
1 / 3

Focuser Brace for 150mm Newtonian

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stop focuser wobble and stabilise collimation. Upgrade your scope.

Ocena
0 / 5
Polubienia
0
Pobrania
11
Wydruki
0
Wyświetlenia
84
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

When you fit a camera or even a laser collimator you will notice the OTA flexing and collimation changing. This is because the wall of the OTA is very thin metal. This brace maintains the shape of the OTA and eliminates all flexing.

I used an m8 threaded rod cut to length for the hinge. 5x M5 (40mm) hex bolts provide even clamping pressure along the length of the brace. 

To fit the brace:

  1. You may need to remove the focuser first, 
  2. Fit the brace around the OTA and fit the M5 bolts loosely tight.
  3. Refit the focuser and 
  4. Tighten the M5 bolts so they are all evenly tensioned and the gap is straight.
  5. Don't over tighten the bolts. You want the brace tight enough that it grips the OTA firmly all around the tube. Leave a gap of a few mm between each half of the brace. (I have a 3mm gap).

If your OTA diameter is smaller than 176mm, you can add some thin felt or foam material to fill the gap.

I printed this in Black CF PETG.  (4 walls and 15% infill recommended). 

 

 

Tagi