SpeedyBee Analog Module Mount for Walksnail Googles X
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A way to mount the SpeedyBee Analoge module on the strap of a Goggles X
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 225
- Wydruki
- 0
- Wyświetlenia
- 1142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
The original walksnail module has to be removed from the case and inserted in the 3D printed part.
the back plate is screwed with long thing screws, I believe I used M1.6x15. Better with self tapped screws since they are just going into plastic.
This bay has the same dimensions as the HDZero analog bay, therefore any faceplate or cover that fits that bay should work here. I'm packing in this same model the SpeedyBee cover since it's the module I'm using.
The cover or faceplate should be printed on the side standing up. The side of the 5 direction joystick. I used tree support and it was very easy to remove the supports.
The back plate was printed flat on the printing bed, with tree support. The supports under the big face are easy to remove but the ones under the clips are more difficult, be careful.