John Deere 110TLB vented front axle cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To prevent pressure from building in the front axle and causing oil push through the spindle seals
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
If you experience issues with oil seeping through the spindle seals on your John Deere 110TLB, the issue may be pressure building as the oil warms up. This is especially problematic during winter when the tractor operates in freezing temps.
This cap is vented through an opening that runs down the center of the screw and into the top of the cap. The grip section of the cap covers the opening with significant overlap to make the vent weatherproof and splash proof. It is not submersible.
Recommendations:
- PETG for some added oil resistance, but PLA will work
- 100% infill. The stronger the better. This is a tractor part after all.
- Print the part with the threads up and supported under the top of the cap. There are other extreme angles and minor bridging but I have found support unnecessary anywhere else.
Notes
- Dipstick was omitted to reduce risk of it breaking inside the axle.
- Flats were added to be able to use a wrench or pliers to remove it if too tight.
- Threads are ¾-10 UNC. This cap likely fits John Deere 4000 series tractors, though untested.
- Stock O-ring fits over this design well.