Qidi I-Fast Upgrade to Klipper BTT and solve HW issues + BLTouch Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I-Fast in original version was not satisfying. Guide to rebuild to KLIPPER and upgrade HW issues.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 566
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
*** Be aware that there is no way back, takes time and money - consider buying new printer first. But I'm happy now and that what counts ***
***
Discord to exchange knowledge and ideas as we keep improving IFast
— https://discord.gg/VRfdQc8PVQ —
(old link *** https://discord.gg/MQXRUpbvqW *** )
***
I-Fast in original version was not satisfying. The first batch was a tragedy!

One must to do is a BLTouch with front holder which brings the issue that motherboard has to be exchanged.
See my base shopping list:



and then there was a lot of small stuff and some handwork to make it up-to-date:

You can spot some of the improvements with *
- custom extruder
- BL Touch
- ADXL
- XY cable guide
- reinforcement of gantry (later version of iFast got it…Z unstable on temp change)
- acitve filter
- extra light
- extra fans for all steppers
- Qidi 4 Plus chamber heater

Which brings us some more wiring:


Tips / Troubleshooter:
- at some point there were to less FAN controllers → use solid state relais and control them with CM outputs
- for a real chamber heater:
- I did use a hard wiring (serial would be nice to try if it can handle 2ext?). I suggest to keep the flat cable to avoid remodeling extruders as I did later:
- frist I used spare PCB from extra (low temp) extruder on MB side:

- 2nd option is to buy PCB from AliExpress to pin out
https://a.aliexpress.com/_EJlWepK
- frist I used spare PCB from extra (low temp) extruder on MB side:


