1 / 2
Commodore 64 joystick case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Instructions for printing:
- rotate items to be flat
- no supports
- 0.2mm layer
- 0.4mm nozzle
Instructions for assembly:
- Solder all wires to buttons and joystick (colour code buttons)
- screw joystick into the case and mount buttons
- solder all ground wires to a single point with an additional wire to exit the case
- solder up on the joystick to the top button so that they are connected
- feed all wires through the opening, use hot glue or electrical tape to add strain relief (optional) and close the case
- trim sides of RS232 connector to make it slimmer
- test which wires correspond to which actions on the joystick and connect the same coloured cable to the correct socket on the RS232 connector
- connect the joystick to the RS232 connector and and use electrical tape to secure connections.
- add rubber feet (optional)
Parts links:
- https://www.pishop.co.za/store/diy-arcade-8-way-joystick-replacement-part-using-lugs?keyword=joystick
- https://www.pishop.co.za/store/picade-classic-arcade-buttons--red?keyword=picade&category_id=0
- https://www.botshop.co.za/shop/acc-208-male-to-female-breadboard-jumpers-40pcs-10cm-1199
- https://www.botshop.co.za/shop/acc-108-female-head-rs232-turn-terminal-serial-port-adapter-830
Tools list:
- Soldering iron
- Solder wire with flux core
- Electrical tape
- Wire stripper/flush cutter
*Please note, the bottom parts tolerances may differ between printers, I have supplied the fusion360 file so that you can make adjustments to it. The fit should be very tight but it should not warp the plastic.