Sepura STP test JIG
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a test jig for Sepura STP bare PCB
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- GNU General Public License v3.0
This holder will hold a Sepura STP-series radio board with or without the frame, allowing use of antenna and mounting of both RAC and FAC-connector.
Two different mounts are available for the speaker. Either a plain for the speaker itself or another that will allow use of the debug-port beneath the speaker.
This was made for easier debugging and reverse engineering.
Three mounts for pogo-pins Mouser 179-CPG-03-SMT-TR. One will insert 1.8V for CPU core, two other are unknown. Only test points that are common for both STP8000 and STP9000 series are there, no test points under CANS are present.
Use 1.75 mm raw filament for hinge taps
Print tested with Ankermake M5C 0.4mm precision. Filament Sunlun PLA+ white.