Wire/Solder/Tape holder 2x1 gridfinity Refined
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A spool holder for tape, wire or solder - fitting on a 2x1 Gridfinity Refined base.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 33
- Wydruki
- 1
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
A relatively simple spool holder here. It start as a solder holder, and then I've added the tape dispenser section to the top. It's 40mm from the centre of the spool to the baseplate. The spool axle holds in place nicely from my experience, while being very quick to change. I did go through 3 iterations to get the right fit - so I hope it works for you.
I've used the gridfinity refined bases again, as I love the push-fit magnets.. but this also means that you can use the threaded fixings if you really want these to be study in use (which you might for spool holders).
This should all print without supports. I did use a brim when printing the axle for a little extra adhension.
Kudos to Grizzie17 for the Gridfinity Refined solutions, and Zack Freedman of course for the original Gridfinity concept.
These are the magnets I use for all my gridfinity stuff: https://amzn.to/3DFTKtO. (Note: This is an associate links, which means that they don't cost you any more, but I get a small cut if you purchase via these links. This isn't a big money-spinner, but I find it so useful to have sub-components linked in models that I download - so I know I'm getting exactly the right bits without much research, and it helps justify my tinkering!).
Enjoy :)