Lampa Bożenki
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Led lamp fixture for manicure and or other detailed work.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
My son married an incredible woman. So when I heard his mother in law needed better lighting in order to do her nails and other detailed work I had to step up to the plate.
Hereby I present the "Lampa Bożenki".
With PLA or PETG of your choice, print the base, print the arm three times, print the switch knob and print the power unit.
Using transparent filament print the diffuser three times.
Power unit
For the Usb-C connector I used a DIP-12p PCB Module which I secured with a tie rap.
To power the LED strips I used a MT3608 DC-DC step up booster secured with two tie raps.
The left female connector is for connecting the LED strips. The right male connector is for connecting the power slide switch as shown below.
Put the printed knob on the slide switch and screw it in place. Using a thin screw driver you can reach the screws through the USB-C cutout on the back of the base.
Arm with LED stripOn the arms I used the SMD 2835 LED strip at a length of 21.5 cm or 8.465 inch each.
Yes, I did print the Lampa Bożenki in her favorite color. The blue one is the favorite color of my daughter in law. Hence different colors in different images.
Through the base, connect the left with the middle arm and the middle arm with the right arm. The right arm is connected with the step up booster.
The result
After fitting the power unit into the base.
