Duchess Gaming Table Cupholder

For those who own the Duchess gaming table (which is no longer in production) but don't have any/enough cupholders, I have recreated the original swivel cupholders!

However, these ones do NOT swivel; that would require extra hardware, including spring-loaded ball bearings, etc. More effort than I want to put into a simple cupholder just to keep drinks off the table. Instead, I have made 2 slotted pegs that are meant to act as pressure fittings; depending on variations of the hole placement on your table, you might need to sand these down a little bit.

I printed the cupholder body in PETG, and the inserts in PLA; you can probably do both in PLA, just ensure you have a minimum 50% infill and 6 walls for strength.

What you'll need to mount each cupholder:
6x40mm machine screw - I recommend an allen head for easier tightening. I would also recommend a flat bottom head, like a button head.

6mm washer (optional) - to place under bolt head and spread out torque. You probably don't need to put one between the cupholder and the table because it's plastic, but that's your call.

WARNING: BE CAREFUL INSERTING THE PEGS. They should line up nicely with the holes on either side of the bolt hole, but odds are good you'll have to finesse them in. If they don't line up, try removing the metal plate; often times they're off by a mm or so, making it impossible to fit the peg. Don't force them too much or hammer them in; that's how you break them off in the holes like I did. The good news is that even if you do break them, the cupholder should still function just fine, so long as the bolt is tightened.