1 / 9
Aprilia RS457 - Plate to capture mirror nuts — zdjęcie 1
1 / 9

Aprilia RS457 - Plate to capture mirror nuts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ok let's be honest, when it comes to fastening bodywork and other bits, Aprilia makes some pretty dumb choices. For…

Ocena
0 / 5
Polubienia
3
Pobrania
13
Wydruki
0
Wyświetlenia
88
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial

Ok let's be honest, when it comes to fastening bodywork and other bits, Aprilia makes some pretty dumb choices.

For example - if you try to remove the mirrors for a trackday or whatever, you will discover that the nuts drop down behind the fairing when you pull the bolt out. Yes, you have to remove an inner panel on the fairing to access the nuts so they don't fall behind another inner panel and are lost forever. Or until you pull the side fairing. Who's the genius that thought that was a great idea?

Maybe it's just me but I find things like that more than a little annoying. So while I had my RS apart I put togther a couple parts to catpture the nuts. Ta dah! Now you can remove the mirrors without removing the inner panel on the fairing. ***

There are two prints here. The plate that captures the nuts and a drill jig. You need two plates and one jig.

  1. First remove everything to get access to the mirror mounting flanges.
  2. Print the drill jig and two of the plates
  3. Insert the drill jig into the mount and drill a hole using a #19 bit (in the USA) or whatever you use everywhere else in the world to prep for a 5mm x 0.8 bolt.
  4. Tap the hole using a 5mm x 0.8mm tap
  5. Insert two nuts into each plate
  6. Use a 5 x 0.8 x 12mm fastener to hold the plate w/nuts onto the back of the mounting flange. Make sure the bolt does not extend above the top surface of the mounting flange on the bike. You don't have to go crazy tightening the plate to the mounting flange, leaving it a little loose may even make fitting the mirrors easier
  7. Repeat on the other side
  8. Put the bodywork back together and install either mirrors or blanking plates.
  9. Celebrate never having to remove the inner panel just to take off the mirrors again.

*** Ok, so you USA guys will be thinking I'm a maroon because you still have to remove the inner panel to remove the turn signal stalks for that track day. Well, yes and no. AF1 is working on an add-on harness to move the front turn signals into the headlight, just like in the rest of the world. So once that's available, install it and some blanking plates where the signal stalks were and no more having to pull them either.

Category: Automotive

Tagi